How to Install Tile Flooring
Through a comprehensive and complete guide, it is possible to learn about the installation of tile floor. Both porcelain and ceramic tiles can be installed in this manner. Floors are labeled perfectly in addition to tile laying and joints grouting. By following the steps, desired results can be obtained. If you do not find confidence to complete the installation project on yourself then professionals must be contacted. Experience and expertise of the professional must be given preference on the occasion.
Steps For Installation of Tile Floors
Step 1: Subfloor Must be Examined
Confusion is seen in the mind of homeowner behind the selection of suitable subfloor especially before tile installation. In most of occasion, tile is installed over concrete or wooden floors. However, movement or deflection can be observed on several occasions.
Step 2: Installation of Heating Wire of Radiant Nature
By using heating wire, tile floor can be upgraded. Therefore, professionals are recommending heating wire along with the tiles. Diverse ranges of methods can be utilized for heating floors. It is better to infuse the heat. Later on, it can be covered with motor for desired result.
Step 3: Flattening of Subfloor
According to the tile contractor, remodeling job is required for tile installation. Uneven floor must be even out with adequate method. It is considered one of the important steps that must not be overlooked. Due to roughness of floor, tiles can be broken.
Step 4: Underlayment Must be Installed
Desired effect from the tile is guaranteed through the underlayment. Generally, cement board is observed along with motor bed. However, other kinds of underlayment can be selected after consulting with the professional at the same time. Uncoupling of membrane is done during this time. Chances of delaminated or cracked tiles can be eliminated in the process.
Step 5: As a Guide, Marking is Done
For laying tiles in perfect manner, things must be marked. By pre-cutting of tiles, requirement of spacers can be eliminated. Grid is often set up with the assistance from the chalk lines. Due to this reason, tiles can be found in perfect line without any hassle.
Step 6: Arranging the Tiles
If you have done adequate amount of prep work then problems may not be observed with installation of tiles. Based on perimeter, tiles can be cut. It is always better to place the tile according to the guide. At the joint, mortar is observed. By using a professional help, problems can be avoided. Professional knows several tricks to eliminate issues.
Step 7: Grouting of Tile Joint
Grouting is considered one of the last steps of tile installation. Tiles can be brought perfectly in due course
Tools Required for Tile Flooring
Installation of tile flooring can be completed with perfect tools exclusively. In order to buy these tools, you have to invest some amount of money. Therefore, you can rent these tools from nearest home improvement stores as well. Both the motor and grout is generally included in the list. In addition, you may want tape measure, hammer, chalk line, jamb saw, flat and notched trowel.